These installation instructions apply to left-hand drive vehicles.When installing in a right-hand drive vehicle, the procedure is carried out on the opposite side andor mirrored.IMG-241300 Preparations Remove the center consoles right-hand side panel by pulling it away starting at the front edge and then backwards until all the clips have released.
Pull off the A-pillar panel at the upper edge and then straight upwards to remove. Make sure that it does not obstruct adjustment of the rear view mirror. Secure the cable on the heater unit using the pieces of tape. The pre-routed connector is already connected on certain versions. Disconnect the connector and connect both connectors from the new cable harness. Use isopropanol. IMG-250305 Installing the control module Take a Velcro strip and cut off two pieces of the same length Press the pieces together.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |